How are Commercial Lighting track lights installed?

2022 07/29

Embedded installation, a small slot in the ceiling, the track and ceiling flush or concave embedded, the ceiling needs to be modelled, not ceiling decoration needs to be slotted in the cast-in-place roof, this installation method requires a higher quality of the track.

1. Before installing the LED Track Light, you should leave a good wiring position, then punch an installation hole in the ceiling, connect the power cord, then put on insulation tape, then use screwdrivers and screws to fix the lamps and tracks, and adjust the direction of irradiation of the lamps, after the installation is completed you can open the track light and check its lighting effect.

LED Track Light

2. First pull down the main switch to reveal the switch line connector and position it, and drill a good hole in the ceiling flower; then fix the track on the ceiling with screws, then connect the transformer line with the switch line, and then wrap the insulation tape; then tighten the spotlight base chuck against the recess and plug it in, then twist the screwdriver to fix and adjust the direction; finally turn on the light to check if it is normal.

3. In the place where LED Down Light need to be installed, first set aside the slot position and lay the decorative surface, which is the most common way of installing magnetic lights.

4. In accordance with the length and installation position requirements of the track in the design scheme, pre-set out the groove of the pre-buried track inside, the width of the slot, depending on the width of the track purchased, the size of the track of different brands is different, so the need for carpentry construction before the purchase of the track.

Previous:How to replace the chandelier embedded in the ceiling?

Next:What you must know about panel lights